Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 12 (kliknij aby zobaczyć)
SETTING THE CLOCK
MEMORY/ ENTER
6 Adjust the hour by turning the jog dial.
ON/STAND-BY
Jog dial
q When the jog dial is turned one click clockwise, the time will increase by 1 hour. When it is turned one click counterclockwise, the time will decrease by 1 hour. Keep turning the jog dial to change the time continuously. q When the 12-hour display is selected, �AM� will change automatically to �PM�.
7 Press the MEMORY/ENTER button.
8 Adjust the minutes by turning the jog dial.
CLOCK
q When the jog dial is turned one click clockwise, the time will increase by 1 minute. When it is turned one click counterclockwise, the time will decrease by 1 minute. Keep turning the jog dial to change the time continuously. q The hour setting will not advance even if minutes advance from "59" to "00". q In this example, the clock is set for the 24-hour (0:00) system.
9 Press the MEMORY/ENTER button.
1 Press the ON/STAND-BY button to turn the power on. 2 Press the CLOCK button.
q The clock starts operating from "0" second. (Seconds are not displayed.)
To see the time display:
3 Within 5 seconds, press the MEMORY/ENTER button.
Press the CLOCK button. q The time display will appear for about 5 seconds even in the stand-by mode. Note: q The "CLOCK" will appear at the push of the CLOCK button when the AC power supply is restored after a power failure occurs or after the AC power cord is disconnected. If this happens, follow the procedure below to change the clock time.
4 Turn the jog dial to select the time display mode.
To change the clock time:
�The 24-hour display will appear. �(0:00 - 23:59) "12:00 AM" �The 12-hour display will appear. "0:00"
1 2 3 1 2
Press the CLOCK button.
�(AM or PM 12:00 - 11:59) "0:00 AM" �The 12-hour display will appear. �(AM or PM 0:00 - 11:59) q Note that this can only be set when the unit is first installed or it has been reset (see page 38).
Within 5 seconds, press the MEMORY/ENTER button. Perform steps 6 - 9 above.
To change the time display mode:
Perform steps 2 - 9 above. Reset the microcomputer (see page 38).
