|
|
|
Kto jest w sklepie?
Sklep przegląda 5498 gości |
|
Kategorie
|
|
Informacje
|
|
Polecamy
|
|
|
 |
|
|
Dla tego produktu nie napisano jeszcze recenzji!
 ;
jedyne do czego mogę mieć zastrzeżenie to jakość zdjęć zawartych w przesłanej instrukcji serwisowej ponieważ są fatalnej jakości, praktycznie nieczytelne. tak poza tym jestem zadowolony to jest to czego szukałem.
 ;
Wszystko w porządku.
Instrukcja czytelna i kompletna.
Dziękuję.
all right!
thank you.
;
Bardzo dobra instrukcja. Zawiera wszystko co potrzeba, polecam!
;
Instrukcja jest OK. Schematy czytelne, opisane niektóre procedury.
;
Instrukcja bardzo czytelna. zawiera co potrzeba. Polecam
MDX-F5800
41
6
2
6
4
c
Orient the release key correctly. Face the hook inwards.
c
1
c
51
182 m m
2
3
Dashboard Fire wall
1 4
53 mm
2
Claws
3 1
6A
B
A B
c
1 2
Precautions
� Choose the installation location carefully so that the unit will not interfere with normal driving operations. � Avoid installing the unit in areas subject to dust, dirt, excessive vibration, or high temperature, such as in direct sunlight or near heater ducts. � Use only the supplied mounting hardware for a safe and secure installation.
Warning when installing in a car without ACC (accessory) position on the ignition key switch
After turning off the ignition, be sure to press and hold (OFF) on the unit until the display disappears. Otherwise, the display does not turn off and this causes battery drain.
Mountingangle adjustment
Adjust the mounting angle to less than 45°.
RESET button Removing the protection collar and the bracket (4)
Before installing the unit, remove the protection collar 4 and the bracket 1 from the unit. When the installation and connections are completed, be sure to press the RESET button with a ballpoint pen, etc., after detaching the front panel.
1
Remove the protection collar 4. 1 Engage the release keys 6 together with the protection collar 4. 2 Pull out the release keys 6 to remove the protection collar 4. Remove the bracket 1. 1 Insert both release keys 6 together between the unit and the bracket 1 until they click. 2 Pull down the bracket 1, then pull up the unit to separate.
2
Mounting example (5)
Installation in the dashboard
Notes � Bend these claws outward for a tight fit, if necessary (5-2). � Make sure that the 4 catches on the protection collar 4 are properly engaged in the slots of the unit (5-3).
How to detach and attach the front panel (6)
Before installing the unit, detach the front panel.
6-A To detach
Before detaching the front panel, be sure to press (OFF). Press (OPEN), then slide the front panel to the right side, and pull out the left side.
6-B To attach
Place the hole A in the front panel onto the spindle B on the unit as illustrated, then push the left side in.
9
|
|
|
> |
|
