WHIRLPOOL MGR5870ADW
Instrukcja Obsługi

Cooktop
To prevent the cooktop from discoloring or staining: � Wipe acid or sugar spills as soon as the cooktop has cooled as these spills may discolor the porcelain, , Clean cooktop after each use. The cooktop is designed with two contoured wells _ff_ with removable porcelain ///_ cm ered drip pans to con- III W tain spills. (See page 20 (.__3 for cleaning directions.)

Burner Grates
erly positioned before cooking. Improper installation of the grates The grates nlust be prop-_[ mayresultinchipping of the cooktop.

]_

_ II _ II _

_ ktk ttt

Do not operate the burners without a pan on the grate. The grate's porcelain finish may chip without a pan to absorb the heat from the burner flame. lose their shine and/orgrates are durable, they will gradually Although the burner discolor, due to the high temperatures of the gas flame.

_Ii_ _.,._J Vi_ll_

DripPan Unlike a range with standard gas burners, this cooktop does not lift-up nor is it removable. Do not attempt to lift the c°°ktopf°ranyreas°n"

N_OT_-._

.

Sealed Burners
The sealed burners of your range are secured to the cooktop and are not designed to be removed. Since the burnel_ are sealed into the cooktop, boilovers or spills will not seep underneath the cooktop, However, the burner heads should be cleaned after each use. The head portion of the burner has a removable cap that is easily removed for cleaning. (See page 19 for cleaning directions.) Theburnerwilloperateeffectivelywithorwithouttheburner cap. High Performance Burner(s) (12,000 BTU*)

' A properly adjusted burner with clean ports will light within a few seconds. If using natural gas, the flame will be blue with a deeper blue inner cone. If the burner flame is yellow or is noisy, the air/gas mixture maybeincorrect.Contactaservicetechnician to adjust. (Adjustments are not covered by the war ranty.) With LP gas, some yellow tips on the flames are acceptable. This is normal and adjustment is not necessary. � With some types of gas, you may hear a "popping" sound when the surface burner is turned off. This is a normal operating sound of the burner. � If the control knob is turned very quickly from HIGH to LOW, the flame may go out, particularly if the

There are one or two high speed burners on your range, Ranges with one high speed burner have the _, burner located in the right front position. _,.E. ),lllll, BOOST burner is wait If this seconds and relight to burner. position, cold. several occurs, turn the knob thethe OFF Ranges with two high speed burners have the '1]]1[' '1111' burners located in the right front and left rear or � Refer to page 23 to adjust the LOW setting, if needed. positions. These burners offer higher speed cook_ . The flame should be adjusted so it does not extend ing that can be used to quickly bring water to a boil ] _ beyond the edge of the pan. and for large-quantity cooking. Simmer Burner (select models) BOOST

burner is located in the right rear position. The Selectrangemodelsoffer one simmerburner.This SIMMERsimmer burner offers a lower BTU flame for delicate sauces or melting chocolate. � BTU ratings will vary when using LP gas.

10