|
|
|
Kategorie
|
|
Informacje
|
|
Polecamy
|
|
|
 |
|
|
Dla tego produktu nie napisano jeszcze recenzji!
Initial installation
Batteries � remote control
To insert or change the batteries, press the point marked by an embossed arrow. Push the cover of the battery compartment down and remove it. Insert the batteries of the alkaline manganese type LR 03 (AAA) with the correct polarity (+/�).
Connection
Mains Connect the TV set to a 230V/50�60 Hertz outlet. Antennae Remove the rear cover from the Mimo set by pulling backwards. Clamp the cable in the cable holder and lead it downwards through the opening. Connect your antenna or cable system to the VHF/UHF antenna socket. If your TV is equipped with a picture-in-picture tuner (PIP), plug the antenna plug protruding from above the PIP antenna socket into the antenna socket for the VHF/UHF tuner. Plug the antenna plug of your antenna or cable system into the socket of the PIP tuner. If your TV set is equipped with one or two satellite tuners, connect the SAT antennae to the SAT sockets (see figure on page 5). Refit the cover to the Mimo set.
SAT DIG IN RC5/RC6 IR CTRL SERVICE 1 2
Initial installation
Automatic programming of the TV set is started the first time you switch it on. Follow the menus. First you have to select the menu language for your set. Then you specify which antenna you have connected to your TV and in what country you are using it. Then you start the station search. The TV set searches for, stores and sorts all the stations which your antenna system receives. You then see a list of the stored stations in which you can mark your favorites. Finally log in your video recorders, decoders, Loewe audio system and Home Automation with the connection wizard and connect these to the TV set according to the illustrated connection plan. Select the settings with the arrows on the ring ...
+
+
Then push the cover back on. Note on disposal of batteries: The original batteries do not contain any pollutants such as cadmium, lead and mercury. Used batteries do not belong in the domestic waste. They must be taken to the appropriate collection points according to the national laws. Ask your dealer.
OK
R L
SAT A/D
VGA AUDIO IN AV1 R OUT L AV2/RGB AV3
DIG OUT
... confirm the settings with OK. You then move on to the next menu ... ... press this button if you want information about the settings.
AUDIO VHF/UHF
SUR C SUBWOOFER STAND SUB
i
You can repeat initial installation at any time, e.g. after moving house. Launch the index in the main information (i button). Then select the item �Repeat initial installation�. Then start �Initial installation� with OK.
Switching on
Press the On/Off button so that it snaps in.
9
|
|
|
> |
|
