Radio Reception/Sleep Timer
Tuning to radio stations
1 Press STANDBY ON y to switch on the last selected
source.
Listening to preset radio stations
G In tuner mode, press 1 or 2 or use the numeric keypad (0-9) to select the desired preset number. � The preset number, radio frequency, and waveband are displayed.
English
2 Press SOURCE (or TUNER on the remote) to select
TUNER mode.
3 Press TUNER again to select the desired band : FM or AM. 4 Press and hold S or T until the frequency indication
starts to change, then release. � The system automatically tunes to the next strong radio station.
Sleep timer setting
The sleep timer enables the system to switch to standby mode automatically at a preset time.
1 Press SLEEP on the remote repeatedly to select a preset
G To tune to a weak station, press S or T briefly and repeatedly until an optimal reception is found. time. � The selections are as follows (time in minutes): 15 � 30 � 45 � 60 � 90 � 120� OFF � 15...
5 Repeat step 4 if necessary until you find the desired radio
station.
Presetting radio stations
You can preset up to 40 stations regardless of the reception.
2 When you reach the desired length of time, stop pressing
the SLEEP button. � �Sleep� icon appears. To check the remaining length of time after sleep timer is activated G Press SLEEP once. To change the preset sleep timer G Press SLEEP again while the remaining sleep timer is shown. � The display will show the next sleep timer options. To deactivate the sleep timer G Press SLEEP repeatedly until "OFF" is displayed, or press y the STANDBY ON button.
1 Tune to your desired radio station (refer to �Tuning to
radio stations�.)
2 Press PROGRAM.
� �Program� icon appears. preset number. � If �Program� icon goes off before you select the desired preset number, press PROGRAM again.
Program
3 Use the numeric keypad (0-9) to select the desired
4 Press PROGRAM again to store the radio station.
G Repeat steps 1�4 to store other radio stations. Helpful Hints: � If you attempt to program more than 40 preset radio stations, �FULL� is displayed. � During programming, if no key is pressed within five seconds, the system will exit the program mode automatically.
