Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 186 (kliknij aby zobaczyć)
3.
Use the numeric keypad to enter the time that you want to poll the other fax. t Set the time using the 24-hour system. If the hour or minute is a single digit, precede it with a zero. For example: 07:30 = 7:30 a.m. 17:05 = 5:05 p.m. t If you make an error entering the time, press CLEAR. Then enter the correct time.
4.
Press START/COPY.
TEL=
5.
Dial the fax number(s) you want to poll. t You can poll up to 97 destinations. See page 10-1 for details.
6.
Press START/COPY.
POLLING TX/RX NO.
XXXX
The LCD displays:
06/21/95 TIMER 17:10
Your MultiPASS 1000 begins receiving the document at the preset time. t t The MultiPASS 1000 beeps once when the document is received without errors. The MultiPASS 1000 automatically redials if the other fax does not answer or if the line is busy. (You can specify the number of times it redials; see Auto Redial on page 5-17.) If an error occurs during reception, the MultiPASS 1000 beeps intermittently for a few seconds. If this happens, try polling again. To stop polling while receiving, press STOP. If the ALARM light is flashing, clear the error and press STOP. If necessary, refer to Chapter 14, Troubleshooting. Chapter 10
