|
|
|
Kto jest w sklepie?
Sklep przegląda 5827 gości |
|
Kategorie
|
|
Informacje
|
|
Polecamy
|
|
|
 |
|
|
Dla tego produktu nie napisano jeszcze recenzji!
 ;
Dobrej jakości skan - wkońcu mogłem poznać wszystkie funkcje tego odtwarzacza - polecam .
;
Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
The dough hook should be used for all heavier substances such as cookie doughs, yeast doughs, pastry doughs and other heavy doughs.The dough hook should always be used when adding nuts, chocolate chips, dried fruits, hard butter or other fats, hardened brown sugar, etc. to a mixture. Use of mixing bowl with twin beating whisks Before beginning to attach this or any other attachment, make sure that the power unit is on a smooth, clean, suitable surface and switched to off position, �O/Off,� and that you have removed the motor drive cover. 1. Before using the mixing bowl and twin beating whisk assembly for the first time, it is recommended that the bowl, anti-splash cover, filling funnel cap and twin beating whisk assembly be washed. All components of the mixing bowl and the twin beating whisk assembly are dishwasher safe, except the whisk holder. The whisks may be removed from the whisk holder as shown in figure 9a, and washed in the dishwasher along with the mixing bowl and other components. The whisk holder should be washed in warm soapy water. After washing, rinse well and dry the whisk holder before reattaching the whisks as shown in figure 9b. a. b.
The driveshaft should also be removed from the mixing bowl for cleaning, if it has not already been done. See previous section, covering mixing bowl and dough hook, for instructions on how to remove driveshaft. 2. If you have not already done so, remove the motor drive cover and place the mixing bowl on the mono drive of the power unit and turn the bowl counterclockwise with a slight downward pressure until bowl is firmly seated on the mono drive coupling, see figure 4.
CAUTION
Failure to make sure that the bowl is properly seated on the mono drive coupling before the power unit is turned on can result in damage to the bowl and/or coupling. 3. Place and engage the twin beating whisk assembly on the driveshaft of the mixing bowl as shown in figure 10a. a. b.
Figure 10.
4. Place the anti-splash cover on the bowl so that the tabs on the bowl fit into the recesses in the cover, and turn the antisplash cover counterclockwise to fasten the bowl cover to the bowl. See figure 10b. The anti-splash cover has an integral filling funnel with a cap. The cap may be removed
13
Figure 9.
|
|
|
> |
|
