Turning off the power
You must perform the Shutdown operation before turning the power off. The Shutdown operation saves the stored parameters before powering-off, and safely stops the hard disk.
1 2
Press and hold
for at least one second.
A message of �Save Current Project?� will appear.
Press
(Yes).
If you want to shut down without saving the current project in step 2, press [F1 (No)].
The current project will be saved, and then the �SHUTDOWN� message will appear.
3
Press (Yes).
The Shutdown process will begin. When shutdown is completed, the �POWER OFF� message will appear.
If you press [F1 (No) in step 3, shutdown will be cancelled.
4 5
Turn down the volume of all connected equipment
Turn off the rear panel POWER switch.
Make sure that the �POWER OFF� message is displayed before you turn off the power.
If you turn off the power without performing Shutdown, or if you turn off the power before POWER OFF is displayed, the data and the MV8000 itself will be damaged. Roland will accept no responsibility for any damage that results from your failure to perform the Shutdown operation.
Preparations and concepts
� When you turn off the power, you may hear a sound even though the MASTER knob is turned down; this is not a malfunction. � While the Shutdown process is occurring, system parameters and project/song data is being saved. This will require a certain amount of time before the MV-8000 is ready for you to turn off the power.
