JVC MXK1R
Instrukcja Serwisowa

MX-K1R

Removing the front panel assembly (See Fig.10 and 11)
Prior to performing the following procedures, remove the top cover. Also remove the CD changer unit. 1. Disconnect the parallel wire and card wire from the connectors CN101 and CN901 on the power amp and supply PCB. 2. Remove the two screws "G" retaining the front panel assembly onto the bottom of the body. 3. Remove the screw "H" retaining the cassette deck mechanism and then remove the GND lug "b" that comes from the power amp and supply PCB. 4. Remove the solder connecting the wire on the control/FL PCB. 5. Disengage the claws "c" on both sides at the bottom of the front panel assembly and then remove the assembly.

G

Fig.10

Control/FL PCB

Wire Power amp and supply PCB

Claw c

GND lug b

H

Fig.11

1-9