JVC MX-K30AU
Instrukcja Obsługi

Using the CD Player

Example of indication:
When CD door has ejected once and then CD-1 is pressed. (DISC1 is selected) Shows that this disc number is selected.

� When you use an 8 cm CD, place it on the inner circle of the tray. � You can load CDs while listening to the other source. � When power is turned off with the tray opened, the tray is automatically closed. � If the CD cannot be read correctly (because it is scratched, for example), � 0 0:00� appears on the display.

1

2

3

To Unload CDs
Shows that the disc is rotating.

Take out the CD as shown below.

1
One Touch Play
The power comes on, and operations are done automatically. � By pressing the CD 6 button, the System will come on, and if a CD is loaded for the disc number that was lastly selected, it will start playing from the first track. � By pressing the CD1-CD3 button, the System will come on, and if a CD is already loaded for the selected disc number, it will start play from the first track.

While the CD Player is stopped, press the CD Open/Close 0 button on the Unit to open the tray. Remove the CD, then press the DISC SKIP button on the Unit.
The tray turns for the next CD.

2

3 4

Repeat step 2 to remove all the CDs. Press the CD Open/Close Unit to close the tray.

0

button on the

To Load CDs 1 2
Press the CD Open/Close Unit to open the tray.

� You can remove CDs while listening to the other source.

0

button on the
� You can also remove the CDs during playback. However, in this case, you can only remove the CDs that are not being played back.

Place a CD, with its label side up, onto the tray.
Be sure that the CD is securely seated on the disc tray.
With the label side up

STANDBY

STANDBY/ON

CANCEL

SET

/ DEMO

PRESET

DI

SC

SK

IP

3 4 5

Press the DISC SKIP button on the Unit and place the next CD.
When you press the button, the tray turns for the next CD.

Repeat step 3 for the last CD. Press the CD Open/Close Unit.
The tray is closed.

0

button on the

� When placing a disc in the tray, be sure to position the disc inside the recess correctly. Otherwise, the message �No disc� will appear in the display, and the disc may be damaged or the Unit may be damaged when the tray is opened, or it may be difficult to remove the disc from the Unit.

12

English