JVC MX-K5RB
Instrukcja Obsługi

Common Operations
Turning On or Off the Power
To turn on the unit, press STANDBY/ON so that the STANDBY lamp goes off.
STANDBY STANDBY/ON

2 Press 4 or ¢ to adjust the
hour, then press SET.
ECO

PRESET

To turn off the unit (on standby), press STANDBY/ON again so that the STANDBY lamp lights up.

STANDBY STANDBY/ON

ECO

� If you want to correct the hour after pressing SET, press CANCEL. The hour digits start flashing again.

SET

3 Press

4 or ¢ to adjust the minute, then press SET.

PRESET

A little power is always consumed even while the unit is on standby. To switch off the power supply completely, unplug the AC power cord from the AC outlet.
SET

When you unplug the AC power cord or if a power failure occurs The clock is reset to �� �:� �� soon, while the tuner preset stations (see page 11) will be erased in a few days.

To check the clock time
Press DISPLAY while playing any source. � Each time you press the button, the source indication and the clock time alternate on the display.
DISPLAY

Saving the Power Consumption While on Standby � ECO-mode
You can save the power consumption only while the unit is turned off (on standby). To activate the ECO-mode, press ECO while the unit is turned off (on standby). The display illumination (including the display demonstration) disappears. To deactivate the ECO-mode, press ECO again. The display illumination appears.
About ECO-mode While ECO-mode is activated, the display demonstration is canceled temporarily.
STANDBY STANDBY/ON

To adjust the clock again
If you have adjusted the clock before, you need to press CLOCK/TIMER repeatedly until �CLOCK� is selected. � Each time you press the button, the clock/timer setting modes change as follows:
DAILY
ECO

ON TIME CLOCK

REC ON TIME

Canceled

If there is a power failure The clock loses the setting and is reset to �� �:� �.� You need to set the clock again.

Selecting the Sources
To listen to the FM, MW, and LW broadcasts, press FM/AM. (See page 11.) To play back CDs, press CD 6. (See pages 14 � 16.) To play back tapes, press TAPE 3. (See page 17.) To select the external equipment as the source, press AUX.

Setting the Clock
Before operating the unit any further, first set the clock built in this unit. You can set the clock whether the unit is on or off.

On the unit ONLY: 1 Press CLOCK/TIMER.

CLOCK / TIMER

The hour digits start flashing on the display.

When you press the play button for a particular source (AUX, FM/AM, CD 6, and TAPE 3), the unit turns on (and the unit starts playing the source if it is ready � COMPU PLAY CONTROL).

�9�