Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 13 (kliknij aby zobaczyć)
Using the Tuner
CAUTION:
� In AM (MW) broadcast, reception sensitivity will be changed by turning the AM (MW) loop antenna. Turn the AM (MW) loop antenna for best reception.
� Even if the System is unplugged or if the power failure occurs, the preset stations will be stored for a few days. However, in case the preset stations are erased, you will need to preset the stations again.
Presetting Stations
You can preset up to 10 FM stations and up to 10 AM (MW) stations.
To Change the FM Reception Mode
When you are tuned in to an FM stereo broadcast, the �ST (Stereo)� indicator lights up and you can hear stereo effects. If an FM stereo broadcast is hard to receive or noisy, you can select Monaural mode. Reception improves, but you lose stereo effect. Press the FM MODE button on the Remote Control so that the �MONO� indicator lights up on the display.
� Preset numbers may have been set to factory test frequencies prior to shipment. This is not a malfunction. You can preset the stations you want into memory by following one of the presetting methods below. � During presetting stations, if no button operation is made for 4 seconds, the display returns to the band/frequency display. In this case, repeat steps from the beginning.
ST
MONO
or
SET
or
SET
To restore the stereo effect, press the FM MODE button on the Remote Control so that the �MONO� indicator goes off. Selecting other station will also cancel the FM Mono mode and restore the stereo effect.
FM=10, AM=10
When changing the Band
Using the Unit
1 2 3 4
Select a band by pressing the FM/AM button. Press the 22 or ¡ button to tune in a station. Press the SET button.
�00� will blink for 4 seconds.
Press the 4 or ¢ button to select the preset number.
¢: 4: Increases the preset number by 1. Decreases the preset number by 1.
5 6
Press the SET button.
The display shows the stored preset number and frequency.
Repeat above steps 2 to 5 for each station you want to store in memory with a preset number.
To change the preset stations, repeat the same steps as above.
� In step 4, you can select the preset number using the numeric keys on the Remote Control. See �Entering the Number with the Remote Control� on page 8.
