|
|
|
Kto jest w sklepie?
Sklep przegląda 5988 gości |
|
Kategorie
|
|
Informacje
|
|
Polecamy
|
|
|
 |
|
|
Dla tego produktu nie napisano jeszcze recenzji!
 ;
Dobrej jakości skan - wkońcu mogłem poznać wszystkie funkcje tego odtwarzacza - polecam .
;
Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
KeyCard anti-theft protection system
Two KeyCards are supplied with the unit. Should you lose or damage a KeyCard, you can obtain a replacement from a specialist dealer. If you are using two KeyCards, the settings are taken from the first KeyCard. You can customize the following functions: Station key assignment, bass, treble, balance and fader settings, loudness, beep volume, LOW-EQ, HIGH-EQ. The last state selected such as frequency band, station setting, AF, SCAN-TIME, seek run sensitivity, ON VOL (volume at switch on), SHARX, is also saved. Your selected settings are therefore selected automatically when you insert your KeyCard. �
1 3
� �
Slide the card as far as possible to the right, and remove from the front. Engage the control panel. For safety reasons, the control panel must always be engaged whilst the vehicle is moving. When leaving the vehicle, open the control panel and remove the KeyCard in order to prevent theft.
Slide the card in the direction of the arrow (2) and engage the control panel (Arrow 3).
The car radio is ready for use. Should a KeyCard other than that belonging to the unit be inserted, CARD ERR� appears on the display. The unit switches itself off after approx. 10 seconds. Should a card other than a KeyCard be inserted (e.g. a phonecard or credit card), �WRONG KC� is displayed for approx. 2 seconds. In this case, remove the card and insert a KeyCard for the unit. � Press ON to switch on the unit.
Teaching in a second KeyCard/ replacing a KeyCard
An additional KeyCard can be �taught in� whilst the unit is in operation with the first KeyCard. To �teach in� a second KeyCard: � � Slide the first KeyCard in and switch the unit on. Press DSC and use / to select �LEARN KC�.
Switching on the unit
� Switch on the unit with ON. To insert the KeyCard, disengage the control panel: � � Press the knob 1: the control panel folds down forwards. Insert the KeyCard with the contact surface downwards, as shown in the diagram (Arrow 1).
� Press << or >>. �CHANGE� appears on the display. � Remove the first KeyCard and, with �CHANGE� on the display, insert the new KeyCard. When �READY� or �LEARN KC� appears: � Press DSC. 13
Removing the KeyCard
Disengage the control panel as follows � Press the knob 1: the control panel folds down forwards.
2
PORTUGU�S ESPA�OL SVENSKA NEDERLANDS ITALIANO FRAN�AIS ENGLISH DEUTSCH
|
|
|
> |
|
