|
|
|
Kto jest w sklepie?
Sklep przegląda 5880 gości |
|
Kategorie
|
|
Informacje
|
|
Polecamy
|
|
|
 |
|
|
Dla tego produktu nie napisano jeszcze recenzji!
 ;
jedyne do czego mogę mieć zastrzeżenie to jakość zdjęć zawartych w przesłanej instrukcji serwisowej ponieważ są fatalnej jakości, praktycznie nieczytelne. tak poza tym jestem zadowolony to jest to czego szukałem.
 ;
Wszystko w porządku.
Instrukcja czytelna i kompletna.
Dziękuję.
all right!
thank you.
;
Bardzo dobra instrukcja. Zawiera wszystko co potrzeba, polecam!
;
Instrukcja jest OK. Schematy czytelne, opisane niektóre procedury.
;
Instrukcja bardzo czytelna. zawiera co potrzeba. Polecam
CHAPTER 9 INSTALLATION
Step 11
Work Perform the following while toner is being supplied. 1. Remove the screw used to keep the center of the right cover in place, and install the original tray to the machine (right) with two stepped screws. (You will not be using the removed screw.) 2. Attach the mode memory sheet to the cover of the toner supply mouth. Reference: If you find installing the original tray difficult, loosen the two mounting screws and start over.
Remarks
Stepped screws
Original tray
12
Attach the Manual Feed Instructions label to the manual feed tray of the RDF.
Label
13
When the toner supply operation has ended, place the Test Sheet on the copyboard, make copies, and check the copy images. At times, toner can fall from the drum separation claws, soiling the initial ten or so copies. (This phenomenon will disappear as copies are made.) Check to make sure that pick-up from each source is normal. Make two-sided/overlay copies.
� Check to make sure that no abnormal sound is heard. � Check images of copies made at each default ratio. � Check to make sure that as many copies as set are made. � If there is a difference in density between left and right, adjust the height of the rear of the primary charging wire to correct.
14
� Check to make sure that copying operation is normal. � Check to make sure that abnormal noise is not heard. � Check to make sure that paper feeding in the holding tray assembly is normal.
COPYRIGHT © 1997 CANON INC.
CANON NP6350/NP6251 REV. 0 JULY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
9-29
|
|
|
> |
|
