Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 10 (kliknij aby zobaczyć)
POWER b�
1 Press TUNER/BAND desired band.
repeatedly
AM
to select
the
The unit can store a total of 32 preset stations. When a station is stored, a preset number is assigned to the station, Use the preset number to tune in to a preset station directly.
r---1
When TUNER/BAND power is turned on directly.
FM ~
is pressed
while the power
is off, the
7 Press TUNER/BAND to select a band, and press DOWN or UP to select a station. 2 Press 11 SET to store the station.
A preset number beginning from 1 in consecutive each band is assigned to the station. Preset number order for
To select a band with the remote control Press BAND while pressing SHIFT,
2 Press <4
DOWN or ®> UP to select a station.
Each time the button is pressed, the frequency changes. When a station is received, �TUNE is discrlaved for 2 seconds. During FM stereo reception, ([[0}1] is d~sp~yed. ([[011) TUNE
3 Repeat steps 1 and 2.
The next station will not be stored if a total of 32 preset stations for all the bands have already been stored.
To search for a station quickly (Auto Search)
Keep to change
m
starts stops. �FULL! is displayed stations. if you attempt to store more than 32 preset very weak Use the remote control to select the preset number directly
DOWN or >
rapidly.
UP pressed
manually,
until the frequency the search +
After tuning
in to a station, press
To stop the Auto Search
DOWN or ~
with
UP.
q
The Auto signals.
Search
may not stop
at stations
When an FM stereo broadcast
contains noise
Press MONO TUNER on the remote control while pressing SHIFT so that �MONO� appears on the display. Noise is reduced, although reception is monaural. To restore stereo reception, repeat the above so that �MONO disappears.
1 Press BAND while pressing band. preset number.
Example: To select preset number To select preset number
SHIFT to select a
2 Press numbered buttons O-9 and +1 O to select a
To change the AM tuning interval
The default setting of the AM tuning interval is _10 kHz/step. If you use this unit in an area where the frequency allocation system is 9 kHz/step, change the tuning interval. Press POWER while pressing P. To reset the interval, repeat this procedure.
20, press +10, +10 and 0, 15, press +10 and 5,
Selecting a preset number on the main unit Press TUNER/BAND to select a band. Then, press b PRESET
repeatedly. Each time k is selected.
PRESET is pressed,
the next ascending
number
When the AM tuning interval is changed, all preset stations cleared. The preset stations have to be set again.
m
are
To clear a preset station
Select the preset number of the station to be cleared. Then, press 9 CLEAR, and press 11 SET within 4 seconds. The preset numbers of all other stations in the band with higher numbers are also decreased by one.
