jedyne do czego mogę mieć zastrzeżenie to jakość zdjęć zawartych w przesłanej instrukcji serwisowej ponieważ są fatalnej jakości, praktycznie nieczytelne. tak poza tym jestem zadowolony to jest to czego szukałem.
Instrukcja jest OK. Schematy czytelne, opisane niektóre procedury.
Tekstowy podgląd strony 85 (kliknij aby zobaczyć)
1
An image is light or blurred entirely.
� Is the toner low? (Is "Toner Low" being displayed?) � Yes � No � No � Yes Supply a toner.
Is the specified paper being used? Use the specified paper. Is the lens of the LED head dirty? Clean the LED head.
� Yes � No
Is the LED head installed correctly? (Check the CN6 connector of the main control board.) � No Install the LED head correctly. Is the contact plate of the transfer roller in correct contact with the high-voltage power supply board? (See Figure 6-4 F .) Is the terminal of the EP unit in correct contact with the contact plate? (See Figure 6-4 A and B )? Contact the terminal correctly. Replace the transfer roller.
� Yes
� Yes
� No � Yes
� Has this error been recovered? � Yes � No End
Replace the EP unit.
� Has this error been recovered? � Yes End
Caution: After replacing the EP unit, reset the drum counter. (Refer to "Replacing the Drum Cartridge" in "User's Manual".)
� No Replace the main control board or high-voltage power supply board.
