1 Attach an nut with spring washer (M8) 6 to each special
eye bolt 2. Insert them in the specified holes and fix them with flat washers (small) 3 and nuts (M8) 5. (For safety reasons, use 2 nuts for each special eye bolt.) Attach the nuts (M8) in the way illustrated below to prevent the special eye bolts from loosening.
Caution
Use the special eye bolts only in the specified places. Do not use them on the plasma display itself, which could be damaged internally by them.
1. Insert the special eye bolt in the PDP bracket together with an nut with spring washer (M8). (2 locations: left and right)
Side where pipes protrude longer is the top.
2. Pass the bolt through both then use a flat washer (small) and a nut to fixate it from the bottom.
2
6
Hexagonal nut with spring washer
Secure the nut as close to the root of the bolt as possible.
3 5
3. Tighten the nuts with a spanner.
5
View from the bottom 4. For safety reasons, use 2 nuts on the bottom (tightening them so that they engage each other).
