PIONEER PDK-WM01/WL
Instrukcja Obsługi

Installation Procedure

7

Fine adjustment of the vertical tilt of the plasma display.
If the plasma display is slightly tilted from the vertical after it is installed on the wall, you can adjust this tilt by attaching the tilt adjustment metal fitting. Insert the tilt adjustment metal fitting in the notch on the top surface of the PDP side metal fitting that is tilted downward and attach it by rotating the screw. 1 Rotate the screw until the gap between the wall side metal fitting and the tilt adjustment metal fitting disappears. When the gap between the wall side metal fitting and the tilt adjustment metal fitting has disappeared, the screw becomes difficult to rotate and begins to lift up the plasma display. 2 Rotate the screw to adjust the tilt.
Tilt adjustment metal fitting

8

Locking the lock bar and fixing the lock plate firmly in place with push rivet and the anchor screw (M6 x 14mm) removed in step 1 (2 locations: left and right sides).
If you cannot fix the push rivet in place from the side, fix it in place from the bottom with the anchor screw (M6 x 14mm) (2 locations: left and right sides).
Plasma display

Screw head

Unlocked Locked position position

Gap

Lock the lock bar. Anchor screw (*2) Anchor screw (*1)

Tilt adjustment metal fitting

*1 If there are speakers installed on both sides, fix it in place with the anchor screw (M6 x 14mm) removed in step 1. *2 If there is a speaker installed on the bottom, fix it in place with the anchor screw (M6 x14mm) removed in step 1.

Note
The range that the tilt can be adjusted by the screw is about 5 mm of the external dimension of the plasma display and the screw rotates about 3 times. Be careful not to rotate the screw too much. If the screw is turned too much, the metal fitting may be damaged.

11
En