PIONEER PDP-S08
Instrukcja Obsługi

English

Perform installation according to the following steps 1 to 7.

To avoid damaging the stand, cover it with the protective wrapping that covered the speaker. This illustration shows the PDK-TS01 table top stand.

NOTE: Before attaching the speaker, please attach the PDKTS01 table top stand (or another Pioneer plasma display stand) to the plasma display unit.

1 Attach the speaker mounting fittings to
the rear of the plasma display.
Using the supplied hexagon socket head screws, fix the speaker mounting fittings to the left and right sides of the plasma display. (Use the supplied hex wrench to tighten the screws. This illustration shows the PDKTS01 table top stand.

Protective wrapping (the PDK-TS01 table top stand only) Carefully, mount the speaker onto the mounting � Turn clockwise to tighten. � Align the lugs on the speaker mounting fittings with the holes in the plasma display unit. fittings.

6 Fix the speaker to the mounting fittings.
Use the supplied flat countersunk-head screws to fix both right and left sides of the speaker to the mounting fittings as shown below. This illustration shows the PDK-TS01 table top stand.

2 Connect the supplied speaker cords to
the back of the plasma display.
(Please also see the installation instructions of the plasma display.)

3 Attach the two supplied wire clamps to
the rear of the speakers, as shown.

� The clamp opening should be pointing downward.

4 Connect the other end of the speaker
cords (see step 2) to the speakers.
See the following page for more detailed information on connecting speaker cords.

� Turn clockwise to tighten.

NOTE: Do not use the screw hole located on the underside of the mounting fittings to fix the speaker.

3

English

INSTALLATION ON THE PLASMA DISPLAY

5 Mount the speakers onto the speaker
mounting fittings.