|
|
|
Kto jest w sklepie?
Sklep przegląda 5781 gości |
|
Kategorie
|
|
Informacje
|
|
Polecamy
|
|
|
 |
|
|
Dla tego produktu nie napisano jeszcze recenzji!
 ;
jedyne do czego mogę mieć zastrzeżenie to jakość zdjęć zawartych w przesłanej instrukcji serwisowej ponieważ są fatalnej jakości, praktycznie nieczytelne. tak poza tym jestem zadowolony to jest to czego szukałem.
 ;
Wszystko w porządku.
Instrukcja czytelna i kompletna.
Dziękuję.
all right!
thank you.
;
Bardzo dobra instrukcja. Zawiera wszystko co potrzeba, polecam!
;
Instrukcja jest OK. Schematy czytelne, opisane niektóre procedury.
;
Instrukcja bardzo czytelna. zawiera co potrzeba. Polecam
ORDER NO.
PDP-S11
RRV2705
SPEAKER SYSTEM
PDP-S11XI
65S This service manual is intended for qualified service technicians; it is not meant for the casual do-it-yourselfer. Qualified technicians have the necessary test equipment and tools, and have been trained to properly and safely repair complex products such as those covered by this manual. Improperly performed repairs can adversely affect the safety and reliability of the product and may void the warranty. If you are not qualified to perform the repair of this product properly and safely, you should not risk trying to do so and refer the repair to a qualified service technician. WARNING This product contains lead in solder and certain electrical parts contain chemicals which are known to the state of California to cause cancer, birth defects or other reproductive harm. Health & Safety Code Section 25249.6 � Proposition 65
N/E
FOR PRECAUTION OF REASSEMBLY AND DISASSEMBLY
The speaker grille is attached to the baffle using 12 catches. When removing, use a sharp pointed object, such as a plastic board , or eyeleteer. Insert the point between the grille and baffle, and gently prize the grille off. Alternatively, you can remove the cabinet and the woofer unit, then push the grille out from the inside. Damage to the grille during removal may be unavoidable, but be careful not to break the catches off of the baffle. The woofer units are attached to the baffle by four screws from the inside of the speaker cabinet. To remove the woofer units, remove the four screws. When reattaching, make sure the large connectors (attached to the speaker wire) are facing outward. The tweeters are attached to the baffle by two screws from the inside of the speaker cabinet. To remove the tweeter, remove the two screws. When reattaching, make sure the larger connectors are both facing inward. Also, the cutout of left one should be facing top left; the cutout of right one, bottom left. Network ASSY is attached from the inside using screws and adhesive. To take out, remove the screw.
4-1, Meguro 1-chome, Meguro-ku, Tokyo 153-8654, Japan PIONEER ELECTRONICS (USA) INC. P.O. Box 1760, Long Beach, CA 90801-1760, U.S.A. PIONEER EUROPE NV Haven 1087, Keetberglaan 1, 9120 Melsele, Belgium PIONEER ELECTRONICS ASIACENTRE PTE. LTD. 253 Alexandra Road, #04-01, Singapore 159936
PIONEER CORPORATION
PIONEER CORPORATION 2002
T � ZZM OCT. 2002 Printed in Japan
|
|
|
> |
|
