|
|
|
Kto jest w sklepie?
Sklep przegląda 5922 gości i
2 zarejestrowanych klientów |
|
Kategorie
|
|
Informacje
|
|
Polecamy
|
|
|
 |
|
|
Dla tego produktu nie napisano jeszcze recenzji!
 ;
jedyne do czego mogę mieć zastrzeżenie to jakość zdjęć zawartych w przesłanej instrukcji serwisowej ponieważ są fatalnej jakości, praktycznie nieczytelne. tak poza tym jestem zadowolony to jest to czego szukałem.
 ;
Wszystko w porządku.
Instrukcja czytelna i kompletna.
Dziękuję.
all right!
thank you.
;
Bardzo dobra instrukcja. Zawiera wszystko co potrzeba, polecam!
;
Instrukcja jest OK. Schematy czytelne, opisane niektóre procedury.
;
Instrukcja bardzo czytelna. zawiera co potrzeba. Polecam
1
2
3
4
1. REASSEMBLY AND DISASSEMBLY PRECAUTIONS
1.1 GRILLE ASSY
A
Reasassembly
The Grill Assy is secured to the baffle plate with two-sided tape and bosses. When removing the Grill Assy, if is necessary to wear cotton gloves.
Disassembly
1. Insert the tip of your gloved finger into the gap between the Grill Assy in front and the corner of the baffle plate so that the Grill Assy is slightly lifted.
When reassembling the Grill Assy Remove the old two-sided tape attached to the rear panel of the Grill Assy and adhere new two-sided tape. Press the bosses into the baffle plate and press the entire grill into position.
1.2 WOOFER (Disassembly)
The woofer is secured to the baffle plate with four screws from the outside. To remove the woofer, first remove the baffle plate. (Remove the baffle plate first, because the cables from the Network Assy are short.)
Reasassembly
B
When reassembling the woofer, place it so that its connector plate is facing downward.
1.3 TWEETER (Disassembly)
2. Insert the gloved finger to the extent of the second joint into the gap between the cabinet and the Grill Assy. The tweeter is secured to the baffle plate with three screws from the outside. To remove the tweeter, first remove the baffle plate. (Remove the baffle plate first, because the cables from the Network Assy are short.)
Reasassembly
When reassembling the tweeter, place it so that its connector and screw -hole positions aliga with those on the baffle plate.
Network Assy (Caution)
� When removing the Network Assy, pull it out a little at a time from alternate sides, because it is seated tightly.
C
3. Alternately and gradually lift the left and right sides of the Grill Assy by about 5 cm, sliding gloved fingers along the cabinet. When lifting the Grill Assy, be sure to lift the left and right sides alternately, but not both sides simultaneously.
2 1 1
Input terminal
Network ASSY
D
Note: Be careful not to bend the Grill Assy too far. Otherwise, it may be damaged. O : Good example X : Bad example
Grille ASSY
Baffle Assy (Caution)
� When reassembling the cabinet and the baffle plate, secure the screws in the order shown in the figure below:
E
Baffle
1
Grille ASSY
2
3
4
5
Baffle
Baffle
F
2
1 2
PDP-S59
3 4
|
|
|
> |
|
