|
|
|
Kto jest w sklepie?
Sklep przegląda 5516 gości |
|
Kategorie
|
|
Informacje
|
|
Polecamy
|
|
|
 |
|
|
Dla tego produktu nie napisano jeszcze recenzji!
 ;
Dokładna dokumentacja, pomogła w szybkiej naprawie telewizora. Dziękuję!
 ;
jedyne do czego mogę mieć zastrzeżenie to jakość zdjęć zawartych w przesłanej instrukcji serwisowej ponieważ są fatalnej jakości, praktycznie nieczytelne. tak poza tym jestem zadowolony to jest to czego szukałem.
;
Wszystko w porządku.
Instrukcja czytelna i kompletna.
Dziękuję.
all right!
thank you.
;
Bardzo dobra instrukcja. Zawiera wszystko co potrzeba, polecam!
;
Instrukcja jest OK. Schematy czytelne, opisane niektóre procedury.
Procedure: 1. Install the SD card with calibration code into camera. 2. Attach camera to AC adapter. The camera starts to sound �di di� and then enter the Bright Level to adjust the menu. 3. Use the test pins of multimeter to touch the camera as shown. The black pin touches to the metal frame (GND), and the red pin touches to the LCD negative soldering pad (white wire). 4. Use touch pen on touch panel to adjust the reading on multimeter is 370 +/- 5mV, then press the shutter button to save it. 5. Repeat the above step 3 to adjust the reading to 220 +/- 5mV for Normal Level. 6. Repeat the above step 3 to adjust the reading to 100 +/- 5mV for Dim Level. 7. Press shutter button to get out of the calibration status.
The position on touch panel KEY
SAVE
*
=
Shutter Button Fig 3-7
3-3 LCD Calibration Test Tools: AC Adapter SD Card with Calibration Code [lcdcal.exe] --- Self-extracting execution Oscilloscope The all test points for vector pins are on the logic board U100. The setting of scope: Setting 1: CH1---VG(the white wire as shown), 0.5V, 25.0uS; Trigger Signal: CH4---VCOM; Synchronization: scanning Setting 2: CH1---VG(the white wire as shown), 0.5V, 25.0uS; CH2---VR(the black wire as shown), 0.5V, 25.0uS; Trigger Signal: CH4---VCOM; Synchronization: scanning Make sure the waveform of CH1 and CH2 is overlap together, then switch off the CH1 and CH2. Choose MATH, �-� to get the waveform of �CH1-CH2�. Setting 3: CH1---VG(the white wire as shown), 0.5V, 25.0uS; CH2---VB(the blue wire as shown), 0.5V, 25.0uS; Trigger Signal: CH4---VCOM; Synchronization: scanning Make sure the waveform of CH1 and CH2 is overlap together, then switch off the CH1 and CH2. Choose MATH, �-� to get the waveform of �CH1-CH2�. Setting 4: CH4---VCOM(the brown wire as shown), 1.0V, 25.0uS; Trigger Signal: CH4---VCOM; Synchronization: scanning GND: the red wire as shown
11
|
|
|
> |
|
