...instrukcja serwisowa w pełni czytelna i kompletna. Dziękuję!
Tekstowy podgląd strony 49 (kliknij aby zobaczyć)
5
6
7
8
6.2 ADJUSTMENT REQUIRED WHEN THE SET IS REPAIRED OR REPLACED
INTERFACE Assy
When repaired
No adjustment required.
Y DRIVE Assy
When repaired
Note: If the Pulse Module fails, it is not possible to repair the Y DRIVE Assy by replacing only the Pulse Module. Replace the entire Y DRIVE Assy. � VOFS/VH/IC5V voltage adjustment
A
When replaced
No adjustment required.
When replaced
SW POWER SUPPLY Module
When replaced
No adjustment required.
� Panel white balance adjustment
X DRIVE Assy
When repaired
B
DIGITAL VIDEO Assy
When repaired
No adjustment required.
Note: If the Pulse Module fails, it is not possible to repair the X DRIVE Assy by replacing only the Pulse Module. Replace the entire X DRIVE Assy. � VRN voltage adjustment
When replaced
1. Remove IC1204 (24LC04(1) SN-TBB) from the former PC Board to replace, and install it to the new PC Board. 2. When use new Assy which replaces it and recovered as service parts once again, replace IC1204 with new IC.
