SANYO PLC-XU50
Instrukcja Serwisowa

Mechanical Disassemblies

v Speaker, AV and DVI Board removal
1 Pull the speaker �SP901� upward off from the speaker groove. 2 Remove each screw A (M4x6) to release grounding wires. 3 Pull the Rear Panel ass�y upward off. 4 Remove 4 screws B (T3x6) and remove the AV Board and remove 3
screws C (T3x6) and remove the DVI Board. B A A Speaker C C B DVI board AV board

Fig.4

b Optical Unit removal
1 Remove 6 screws A (T3x8) and disconnect terminal �K6A� on the lamp ballast board. 2 Pull the Optical Unit upward off from the cabinet bottom. A A A A

A A

Fig.5
-10-