|
|
|
Kto jest w sklepie?
Sklep przegląda 5840 gości |
|
Kategorie
|
|
Informacje
|
|
Polecamy
|
|
|
 |
|
|
Dla tego produktu nie napisano jeszcze recenzji!
 ;
Szybko, sprawnie i tanio. Serwis godny polecenia. Będę polecał innym
 ;
Ogólnie jest OK, z wyjątkiem obrazu płyty głównej, który jest miejscami mało czytelny, ale można sobie poradzić.
;
Dokładna dokumentacja, pomogła w szybkiej naprawie telewizora. Dziękuję!
;
jedyne do czego mogę mieć zastrzeżenie to jakość zdjęć zawartych w przesłanej instrukcji serwisowej ponieważ są fatalnej jakości, praktycznie nieczytelne. tak poza tym jestem zadowolony to jest to czego szukałem.
;
Wszystko w porządku.
Instrukcja czytelna i kompletna.
Dziękuję.
all right!
thank you.
Alignment and Adjustments
Alignment and Adjustments
2-2 WHITE Balance Coordinates
2-2-1 White Balance Adjustment
1. W/B Adjustment is required for the following four modes: DVI � DTV � PC � CVBS(VIDEO) � CVBS(VIDEO PIP) 2. Adjustment Method (DVI, DTV, PC : VG828, CVBS : Adjust RF signals to match the Toshiba pattern (in-house signal) ! Adjust the target set by adjusting the panel logic and the video DNIe adjustment register in register in order to determine the referential W/B of the panel with a DVI input, which is the full digital path. @ For DTV adjustment, adjust the adjustment register of ad9888 to align the DTV signal to the DNIe and logic panel value which was fixed with a DVI adjustment so that they are in effect considered to be the same signals. (At this time, do not adjust the gain of AD9888 � the Highlight W/B does not need to be adjusted since its deviation falls within valid distribution range.) # PC adjustment is same as DTV adjustment. (The offset can be applied to the values obtained through DTV adjustment. However, additional adjustment is required for Y, Cb, and Cr of DTV since PC processes R, G, and B signals.) $ cvbs adjustment is performed with the Toshiba pattern (in-house signal) and differs from the VG828 signals in the above three modes. Hence, it should be performed with the same method of ! DVI adjustment. % Finally, activate PIP in video mode, and repeat W/B adjustment. � Thus, Micom saves the W/B data separately for each memory mode of the block (See the block diagram given below) during W/B adjustment.
Micom can memorize the four modes separately. However, under the current adjustment guidelines, DTV and PC are memorized with the same value during DVI adjustment and CVBS is memorized with a separate value.
Samsung Electronics
2-5
|
|
|
> |
|
