Documentation made available quickly and It is good quality. Thanks.
Tekstowy podgląd strony 58 (kliknij aby zobaczyć)
PRO-200, PRO-100
14 -3 Tint adjustment
Start 1st FAC
"Color bar"
(DOWN)
ADJUSTMENT OFFSET
Adjust the screen to optimum condition.
TINT
2
DVD COMPONENT VIDEO INPUT
DVD Player
� For the adjustment of 14 -2 and 14 -3. When it does not have the color bar generator with component video output. (However, make it finish the adjustment of composite video in advance.) 1. Prepare the DVD player with the component video output and the Video software. 2. Input the component signal to the DVD COMPONENT VIDEO INPUT of the TV, and input the composite signal to the VIDEO 1 INPUT. 3. Set the AV MEMORY of LD/DVD, VIDEO 1 to the STANDARD in the normal use mode (It does not enter the FACTORY ADJ mode.) 4. Playback the Video software. 5. Adjust the value of COLOR and TINT of PICTURE of MENU1 with seeing sometimes video of VIDEO 1 so that the video (color) of LD/DVD becomes the same as the video of VIDEO 1. 6. The adjustment is complete, read the value of COLOR and TINT in the MENU, and change it into the value in FACTORY in accordance with the following table. Example: In MENU �30 �15 +15 +30 MENU FACTORY 2Steps 2Steps 2Steps COLOR +17 +19 In FACTORY COLOR TINT 2Steps TINT �5 �10 7. Input the changed value to COLOR and TINT of the component offset in the FACTORY ADJ mode. (End)
14 -4 Contrast adjustment
Start 1st FAC
(DOWN)
"Color bar"
Adjust the screen to optimum condition.
3
"Normal video signal"
ADJUSTMENT OFFSET
CONTR
At the TP-BK of the B. CRT DRIVE assy, check that the signal is shaped as shown below A .
