PIONEER PRO-R05U/KUC
Instrukcja Obsługi

13

Useful Remote Control Features

Learning function of the remote control unit
You can operate the connected AV products (AV Receiver, Cable Box, SAT tuner, VCR, DVD, DVD recorder, LD) using the learning function of your remote control unit. This remote control unit has a function that can memorize each remote control code. 2 to 5 cm (0.8 to 2.0 inches)

Presetting manufacture codes 1 Slide the Mode switch to match the device to which you
want to preset the remote control signal.

2 Press EDIT/LEARN and 1 at the same time. 3
� The LED flashes. Press 0 � 9 to enter the manufacture code. See page 63. � Preset mode is finished once the LED no longer lights up.

Remote control (Supplied accessory)

Remote control of AV product

� To exit the Edit mode halfway, press EDIT/LEARN again. � If the Mode switch selection is changed when in the Edit mode, the Edit mode is cancelled. � If no operation is performed for more than one minute, the Edit mode is cancelled. � When you enter a code not listed, the LED flashes quickly. � If the table on page 63 does not include your desired manufacturer or the remote control does not work, you can make the memory learn its signal by the Learn mode. � The initial mode is �000� (PIONEER).

Using the learning function 1 Slide the Mode switch to match the device whose remote
control signal you want to be learned.

2 Press EDIT/LEARN and 2 at the same time.
�The LED flashes.

3 Press a button to be learned.
� The LED lights up. � For the functions that can be learned, see pages 64 to 68. � When learning is finished, the LED starts flashing again.

4 Press EDIT/LEARN again to exit the Learn mode.
� To exit the Learn mode halfway, press EDIT/LEARN again. � If the Mode switch selection is changed when in the Learn mode, the Learn mode is cancelled. � If no operation is performed for more than one minute, the Learn mode is cancelled. � It takes about 2 seconds to finish code transmission. Do not interrupt it halfway. Wait until the LED flashes again. � You can reset all learned codes to the factory defaults. When not in the Learn mode, press and hold TV , and then press and VOL + (RECEIVER section) at the same time.

62
En