Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 8 (kliknij aby zobaczyć)
PRO TT-2 Turntable TONE ARM SETTINGS The following explains proper counterweight and anti-skating set up. Cartridge manufacturers usually specify the proper settings. a) Remove the stylus protector, do not touch the stylus tip during the adjustment. b) Set the cueing lever to the lower position so it does not effect tone arm height. c) Set Anti-skate adjustment to 0. d) Place counterweight on the rear of the tone arm e) Release the arm clamp and lift the tonearm from the arm rest so it moves freely. f) Rotate the counterweight until the tonearm is approximately balanced horizontally (floats freely). LCD DISPLAY
32 31 33
29
30
29. Speed Indication 33 - 33 rpm 45 - 45 rpm 33 + 45 - 78 rpm 30. Speed Adjust Indication - This will display adjustments in platter speed made by the pitch control. 31. Play/Pause - Indicates current state of the platter 32. Pitch/Quartz - Indicates current mode of operation 33. Platter Wheel - Simulates all actions of speed and direction of the platter.
g) Refasten the tonearm with the arm clamp. h) Hold the counterweight stationary with one hand and rotate only the stylus-pressure ring to bring the number "O" of the ring into alignment with the center line on the tonearm rear shaft. i) Rotate the counterweight with scale ring clockwise to the correct stylus pressure following the manufacturer's recommendation. Note: Failure to follow recommended stylus pressure could damage both the stylus and record. This can also seriously degrade performance. j) Set the anti-skating control knob to the same value as the stylus pressure, unless your manufacturer specifies otherwise.
