|
Dla tego produktu nie napisano jeszcze recenzji!
 ;
...instruction is ok.
...instrukcja jest ok.
Thanks/Dzięki
;
Documentation made available quickly and It is good quality. Thanks.
5
6
7
8
How to replace the fan in the ATX Power Supply unit Removing the fan
1 Remove the switch-barrier fixing screw on the ATX Power Supply unit (DXF1005) then slide the switch barrier, as indicated in the figure. Note: Be sure to set the POWER switch to OFF and disconnect the AC power cord from the AC outlet before starting this step.
Switch-barrier fixing screw Switch barrier
B
ATX Power Supply Unit (DXF1005)
A
2 Remove the fan guard, then remove the fan and disconnect the harness from the fan connector.
Fan connector Fan Cleaning Remove the fan. Cleaning paper : GED-008
C
Attaching the fan
1 Connect the harness to the fan connector and install the fan into the panel. Push the harness inside.
Notes: � Place the fan so that the name plate of the fan can be seen from the front. � Use the Fan Unit (DZM1001) dedicated to the ATX Power Supply unit (DXF1005).
Fan Cleaning Cleaning paper : GED-008
Push the harness inside so that it will not come out. Name plate can be seen.
D
Hook the slots.
2 Attach the fan guard.
Close.
E
3 Slide the switch barrier and tighten the screw.
1. Slide
2. Tighten the screw.
F
PRV-LX10
5 6 7 8
167
|
