Documentation made available quickly and It is good quality. Thanks.
Tekstowy podgląd strony 167 (kliknij aby zobaczyć)
Replacing the lamp unit
Install Procedure Remove Procedure
1 Install a new lamp slowly. 3 Insert Tabs into the main unit as shown. 1 Remove speaker grille. 3 Loosen two screws securing the lamp unit. Check
that the lamp unit and its region are completely cool. The two screws are located on the right top and left bottom.
Lamp unit
Warning: Tabs Because temperature of the lamp unit is elevated immediately after its use, a direct touch to it may cause burns.
�
Speaker grille
After fully inserting lamp unit panel, tighten the screw located on the left bottom. 2 After fully inserting lamp unit, tighten the two screws located on the right top and left bottom.
2 Remove lamp unit cover, loosening the screw Do not touch these screws.
fixing it. The screw is located on the left bottom.
Do not touch these screws.
4 Pull out the lamp unit slowly. Lamp unit cover
Lamp unit cover 4 Firmly install the speaker grille.
