Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 21 (kliknij aby zobaczyć)
Projecting an image
Selecting the input signal
1. Switch on the connected devices.
Press the play button of the required device.
NOTE:
� AUTO SEARCH is ON as default and the signal from the connected devices is detected automatically. See �AUTO SEARCH� on page 40.
2. Press the INPUT button to select the required input method if needed. See �Switching the input signal� on page 23.
The image will be projected on the screen.
Positioning the image
1. Press the ASPECT button to select the required aspect mode. See �Switching the aspect ratio� on page 23. 2. Adjust the projected image with the lens shift dials. See �Lens shift and positioning� on page 16. 4. Adjust the focus and the projected image size.
Press +/- of the FOCUS and ZOOM buttons to adjust. Press the LENS button to adjust the focus and zoom by the remote control. See........................
3. Adjust the angle of the projector.
ENGLISH - 21
Basic Operation
Screw down the front leg adjusters and adjust the angle vertically. See �Front leg adjusters and throwing angle� on page 15.
NOTE:
� Do not touch the air exhaust port as this may cause burns or injury. � If keystone distortion occurs, see �KEYSTONE� on page 38. � If you adjust the focus, you may need to adjust the size of the image by pressing the ZOOM button again.
