jedyne do czego mogę mieć zastrzeżenie to jakość zdjęć zawartych w przesłanej instrukcji serwisowej ponieważ są fatalnej jakości, praktycznie nieczytelne. tak poza tym jestem zadowolony to jest to czego szukałem.
Instrukcja jest OK. Schematy czytelne, opisane niektóre procedury.
Tekstowy podgląd strony 16 (kliknij aby zobaczyć)
PT-FW100NTU / PT-FW100NTE / PT-FW100NTEA
7.11. Removal of S1-P.C.Board 7.8. Removal of L-P.C.Board
1. Remove the upper case according to the section 7.2. "Removal of Upper Case". 2. Open the front door. 3. Unscrew the 1 screw and remove the front cover (inside). 4. Unscrew the 1 screw and remove the grounding terminal. 5. Unscrew the 2 screws and remove the power separation wall. 6. Remove the front cover. Note: · S1-P.C.Board and S2-P.C.Board are attached. · Remove the front cover after shifting the projection lens upward. 1. Remove the block of Analysis Block, LCD Block and Projection Lens according to the steps 1 through 8 in the section 7.17. "Removal of Analysis Block and Projection Lens". 2. Unscrew the 1 screw and remove the L-P.C.Board.
7.9.
Removal of PI-P.C.Board
1. Remove the ARF drive unit according to the section 7.27. "Removal of ARF Drive Unit". 2. Unscrew the 1 screw and remove the PI-P.C.Board.
7. Disconnect the connector between S1-P.C.Board and S2P.C.Board. 8. Unscrew the 5 screws and remove the S1-P.C.Board.
7.10. Removal of R-P.C.Board
1. Remove the upper case according to the section 7.2. "Removal of Upper Case". 2. Disconnect the connector (S4 or A27) between RP.C.Board and A-P.C.Board. 3. Unscrew the 1 screw and remove the R-P.C.Board.
7.12. Removal of S2-P.C.Board
1. Remove the front cover according to the steps 1 through 6
