Documentation made available quickly and It is good quality. Thanks.
Tekstowy podgląd strony 15 (kliknij aby zobaczyć)
PV-DV151-K
Supplying Power
Charge the Battery Pack on the AC Adaptor
1Connect 2Attach
POWER Lamp
and plug in the Power Cord as shown. � POWER Lamp will light. � Remove the DC Cable, if attached, from the adaptor. the Battery as shown to
charge. � CHARGE Lamp lights up. It goes out when charging is complete (approx. 1 hour). Expect approx. 1 hour 30 minutes of operation (EVF usage) when fully charged. the Battery. Slide the Battery out and then lift up.
CHARGE Lamp Note
3Remove
About the Flashing of the CHARGE Lamp
� Charge the Battery within an ambient temperature range of 10 °C and 30 °C. � If charging is done in extreme low or high temperatures, Battery charge time increases. CHARGE Lamp flashes when... � The Battery is being charged, but charging is taking longer than normal. � Charging is not possible. Remove the Battery once, wait a short time, then re-attach it for charging.
Insert the Battery Pack
2 1 4 3
Remove the Battery Pack
Getting Getting Started Started
BATTERY RELEASE Switch
1 2
1 2
Slide the Viewfinder backward to its fully expanded position and then tilt it upward. Insert the Battery Pack and slide it down until it locks with a click.
To remove the Battery Pack:
Slide the Battery upward while sliding the BATTERY RELEASE Switch.
