Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 47 (kliknij aby zobaczyć)
Special Features
Auto Focus
The Palmcorder automatically adjusts the focus over the entire zoom range.
Manual Focus
Use Manual Focus (MF) when recording ...
� a subject through glass. � a scene where the subject is far from the Palmcorder and there are objects in the foreground. � a subject with distinct horizontal stripes. � a subject not centered in the Viewfinder. � subjects with shiny surfaces. � an obliquely angled subject. � a bright, flat subject such as a white wall. � in low light situations. � a scene with fast motions, like a golf swing. Re-focusing may be required � when your Palmcorder is aimed at a new scene.
1
2Press 3 4 5
Set POWER to CAMERA. � The POWER lamp lights red. � Be sure POWER is fully turned to CAMERA position. M.FOCUS DIAL so that �MF�
(Manual Focus) appears in the EVF or the LCD monitor. Press and hold POWER ZOOM �T� side (Telephoto) until the lens is at maximum zoom in.
2, 4M.FOCUS 3, 5POWER
DIAL
ZOOM Switch
Press POWER ZOOM to �W� or �T� as desired. � The subject will remain in focus over the entire zooming range. � It may be necessary to back away from the subject to focus the image properly. Note
Turn M.FOCUS DIAL until the picture is in focus. � It may be necessary to back away from the subject to focus the image properly.
� DISPLAY must be set to on for MF, AE, W.BALANCE, or BACK LIGHT to be displayed on the LCD or EVF.
Press the �W� side of POWER ZOOM to the maximum wide angle position. Auto Focus will function with the subject as close as 1 inch (25 mm) in front of the lens.
Special Special Features Features
Use when recording a subject that is darker than the surrounding scene, in a shadowed area, or when the light source is in back of your subject. BACK LIGHT Button Press BACK LIGHT in Record mode to activate the Backlight feature. The Indicator � � will appear in the EVF or LCD monitor. Press BACK LIGHT again to cancel the Backlight feature. Note � The Indicator � � will not appear in the EVF or LCD monitor when OFF is selected in the DISPLAY menu.
