Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 13 (kliknij aby zobaczyć)
To Use as a Grip Belt
Adjust the length of the Grip Belt to the size of your hand.
1
Detach the end of the Grip Belt.
� When not using the Lens Cap, pull the Lens Cap Cord in the direction of the arrow. 1 � When you are not recording, be sure to cover the Lens with the Lens Cap for protection. 2
Before Using
2
2
Adjust the length of the Grip Belt to the size of your hand.
1
� When you remove the Lens Cap, press the knobs firmly.
Attaching the Shoulder Strap
3
Reattach the Grip Belt.
We recommend that you attach the Shoulder Strap before going out to avoid dropping the Camcorder.
1
Pull the end of the Shoulder Strap
through the Shoulder Strap Holder on the Camcorder.
To protect the Lens surface, attach the Lens Cap. � The Lens Cap and Lens Cap Cord come preattached to the Grip Belt.
Re-attaching the Lens Cap
2
Fold the end of the Shoulder Strap, run it through the Shoulder Strap Length Adjuster, and pull it.
� Pull it out more than 1 inch (2 cm) 1 from the Shoulder Strap Length Adjuster so that it cannot slip off.
1
1
Pass one end of the Lens Cap Cord through the attached eye on the Lens Cap. Then pass the Lens Cap through the loop made by itself and pull tight.
� Attach the other end of the Shoulder Strap to the other Shoulder Strap Holder in the same way.
