Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 12 (kliknij aby zobaczyć)
Quick Guide
1
1 Charge the Battery. (l 18)
�Connect the AC Cable to the AC Adaptor and plug it into the AC Wall Outlet. �Attach the Battery to the AC Adaptor. (This will start the charging process.) �The [POWER] Lamp and [CHARGE] Lamp light up, and charging starts. When the [CHARGE] Lamp goes off, charging is completed. �Since the Battery will not be charged when the DC Cable is connected to the AC Adaptor, disconnect it. Attach the Charged Battery to the Palmcorder. (l 18)
OPEN /
2
2
3 1
EJECT
3 Insert the Cassette. (l 20) �Slide the [OPEN/EJECT] 1 Lever toward the front and pull
down to open the Cassette Compartment. �Insert the Cassette. �Press the [PUSH] mark 2 to load the Cassette. �Close the outside compartment Cover.
2
PUSH
4
CAMERA VCR CARD PB
OFF
ON MOD E
4 Start recording. (l 28)
�Turn the Palmcorder on. (l 20) �Rotate the Switch 3 to [ON]. (The [CAMERA] Lamp lights up.) �Press the 4 Button. (Recording starts.) �Press the 4 Button again to pause the recording.
4 5, 6
CAMERA VCR CARD PB
OFF ON MODE
3
To View the Playback Picture
5 Switch to the VCR Mode, rewind the tape, and play
9
the tape back. (l 43)
�Set the 5 Switch to VCR mode. (The [VCR] Lamp lights up.) �Press the 6 Button. (Rewind the tape.) �Press the 7 Button. (Playback starts.) �Press the 8 Button. (Playback stops.)
5
6 Turn the Palmcorder off. (l 20) �Set the 9 Switch to [OFF].