Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 9 (kliknij aby zobaczyć)
Manual Clock Set
If AUTO CLOCK SET was incomplete, manually set the clock as follows.
Reset all unit Memory Functions
When moving unit to a new location, or if a mistake was made in the Initial Setup section. � Make sure a tape is not inserted in the unit.
Initial Setup
1
Press ACTION on the Remote to display SET CLOCK Menu screen.
SET CLOCK
<Model PVQ-2012 unit shown>
1/ /
SELE CT MONTH SELECT : SET END : : ACT I ON
:
DST : ON
VIDEO IN AUDIO IN
POWER
VOL
CH
STOP/EJECT REW/
PLAY/REPEAT FF/
REC TIMER/FM
REC ON TIMER PROG TIMER
ACTION
2
Press to select the month and press to set. In the same manner, select and set the date, year, time, and DST. (Daylight Saving Time)
SET CLOCK
1 2
Turn the unit Power on. Press and hold both PLAY and FF on the unit for more than 5 seconds.
� The power will shut off. � Please ignore �NO CASSETTE� warning.
2 / 6/2002 WED 12: 00PM
DST : ON SELE CT COMPLETED SET END : : ACT I ON
3
Do �Initial Setup� on page 8.
3
Press ACTION twice to start CLOCK and exit.
POWER
ACTION
SELECT/SET :CH UP :CH DOWN :VOL UP :VOL DOWN
Note to CABLE System Installer
This reminder is provided to call the CABLE (Cable TV) System Installers attention to Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical.
