Recording Your Keyboard Play
You can record to either track with or without playback of the other track.
NOTE
� If you want to record to Track 2, press the LEFT/ TRACK 1 RIGHT/TRACK 2 button here. This will cause the RIGHT/TRACK 2 indicator lamp to flash, which indicates that the piano is standing by for recording to Track 2. � If you want to use the metronome during recording, press the METRONOME button to start it. � If you want to use a rhythm and/or auto accompaniment during recording (to Track 1 only), select the rhythm and chord mode.
To record to one track without playing back the other
When recording a different tune to Track 2 after recording to Track 1, make sure you carefully read the notes under steps 1 and 2 before actually performing the steps.
1
Press the SONG MEMORY button so the PLAY indicator lamp is lit.
3
Start playing something on the keyboard.
� This will automatically start recording. � Actually, there are a variety of different ways to start the record operation. See �Starting the Record Operation� below for more information.
4
� Select the tone and effects you want to use in your recording, and configure the tempo and beat settings.
When you are finished, press the START/ STOP button to stop recording.
� If you are using a rhythm, you can stop recording with an ending pattern by pressing the INTRO/ENDING button. � Stopping recording causes the REC indicator lamp to go out, and indicator lamp above the button of the track to which you recorded to light. � To play back the track you just recorded, press the START/STOP button again.
NOTE
� If you are recording a different tune to Track 2 after recording to Track 1, press the LEFT/TRACK 1 RIGHT/TRACK 2 button to turn off the L/T1 indicator lamp.
Unlit Lit
5
After you are finished recording or playing back, press the SONG MEMORY button so the PLAY lamp or REC lamp turns off.
Starting the Record Operation
2
Press the SONG MEMORY button so the REC indicator lamp is flashing.
You can use any of the following methods to start a record operation in step 2 of the above procedure. I When recording to Track 1 with rhythm or auto accompaniment � Press the START/STOP button to start recording. � Press the SYNCHRO/FILL-IN button to put the piano into synchro start standby. Recording will start when you finger a chord in the accompaniment range of the keyboard. � Press the INTRO/ENDING button to put the piano into synchro start standby. Recording will start and an intro pattern will play when you finger a chord in the accompaniment range of the keyboard.
� At this time the LEFT/TRACK 1 indicator lamp should also be flashing. This indicates that the piano is standing by for recording to Track 1.
