Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 5 (kliknij aby zobaczyć)
Operating
In This Section
Your Washer
Pap0
Sekting
WiP
a cycle nd time .............................. 7 Using rinse md spin ....................................... 6 What happena in each cycle ........................... 6 Using tha chlorine bleach dispm~~ ............ .S
Baton l brting your washer ............................. -5 .
Starting or stopping your washer .................... .5 Selecting a load size ......................................... .5 Selecting a wash temperature .......................... .6
Operating your washer properly assures maximum washing eff icier-q. This section gives you important information to help you to select a cycle, time, and temperature for your wash load.
Before Starting
starting
your washer
See page 10 for additional �Before you wash� information.
Add measured detergent. Then place a sorted load in the washer before starting.
or stopping
your washer
Wash water bmparature
Startlng your washer: 1. Select a load size (see below). 2. Push in the Cycle Control Knob and turn it clockwise. Stop when the indicator on the knob�s outer ring points to the number and wash water temperature in the cycle you want. The numbers are minutes of wash time. Wash water temperature is indicated by the letter near Fill (H=Hot, W=Warm, GCold). (See pages 6-8.) 3. Pull out the Cycle Control Knob. Stopplng and restarting your washer: l To stop the washer at any time, push in the Cycle Control Knob.
l
4 a
Wash Itime
To restart the washer, close the lid (if necessary) and pull out the Cycle Control Knob.
Selecting
a load size
Position the Load Size Selector at the setting that corresponds to the size load you want to wash. Select a setting based upon the size of the load and the fabric you are washing. See pages 10 and 11 for additional loading information. To change the load size setting after the washer has started to fill, move the Selector to the desired new setting.
Load
l
size tips
l l
Items should move freely during the wash. Do not overload the machine or select a load size that is too small for the wash load. Use the Large load size setting for best results with permanent press clothes. Reduce wash time when using the Small load size setting. Loads with only a few small items need less wash time.
