KENWOOD RC-R0610
Instrukcja Obsługi

Getting the most from your remote control
The remote control supplied with this receiver is also capable of controlling components from a variety of manufacturers once you register the appropriate setup codes into the remote control unit. Refer to "Remote operation of other components" for details about the operations available for each component.

4 Repeat steps 2 to 3 to register additional components
until all components have been registered.
Note Although each setup code is designed to work with a number of different models, certain codes may not work with some models. (Also, certain codes may only operate some of the functions available on a given model.)

3

Low battery warning
Replace all four batteries with new ones when you notice a shortening of the distance from which the remote control will operate. The remote control is designed to retain setup codes in memory while you change batteries.

Operating other components
This operation lets you operate the registered components. KENWOOD audio components with system control turn on and off automatically with the receiver via the system control connections.

Registering setup codes for other components

Numeric keys

POWER Source POWER keys

POWER Source POWER keys RECEIVER

1 Find the setup code of the component to be registered.
� Refer to the setup code lists to find the setup code for the component to be registered. RC4 Example: To register a DVD made by KENWOOD, you would enter "805". Input (DVD) Component DVD player Maker Code Key DVD

1 Use the input selector keys to select the component you
desire.
� Pressing the input selector keys also changes the input selector on the receiver. � When you operate your registered TV, VCR, CDR, or DVD player, go to step 2.

KENWOOD 804,805,808

� When you operate the CD player, Cassette deck, MD player, or Tuner with system control connection, go to step 3.

2 Press the source POWER key. 3 Press the operation keys you desire.
� See "Remote operation of other components" for a list of keys available with each component. RC6 � To return to the receiver operation mode, press the RECEIVER key. The remote control mode returns to the receiver operation mode when you do not operate for more than 15 seconds.

2 Hold down the POWER key and press the numeric keys to
enter the setup code.
� Example: Press "805" to register a DVD player made by KENWOOD. � If you push an invalid key, the remote will exit the setup mode. Note Be sure to point the remote control at the remote sensor on the receiver when you want to operate KENWOOD components connected by system control cords. Otherwise, point the remote control at the component you want to operate.

3 Press the source POWER (TV, VCR/CDR, DVD) key for

more than 2 seconds, and check to see that the component you want to control turns on.

If the component does not react, and there is more than one setup code, enter another setup code and try again. � 6, TUNING 1/¡, or MULTI CONTROL key(s) can also be used instead of the POWER key. � If the component is already on, pressing the source POWER keys will turn it off.

Remote Control