Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 9 (kliknij aby zobaczyć)
Getting the most from your remote control
4 Press the 5/� keys to select the location. � Extend1 � Extend5 are available. 5 Press the [Enter] key. � The remote control is ready for receiving the remote control code.
Restoring the original factory settings
You can restore the setup codes or memories to their original default settings.
9
5
Waiting >Extend1 >Extend1 Clr Exit
TUNING
+ �
+ �
6 Press the key of the same operation that you want to store. � The remote code is send to the remote control unit. � "Complete" appears when finished.
ENTER BAND
Complete >Extend1 Extend 1
Insert the batteries during pressing and holding the [5] keys and [ 2 ] key. 1
� "Cleared" appears in the display, and the remote settings return to their original default settings.
� When it takes for more than 8 seconds or the remote control unit does not receive the remote control code well, "Error" appears in the display. In this case, re-operate from the step 1. � "Full" appears when the memory is full. Re-operate from the step 1 after deleting some memories. 7 The remote control code is stored on the memory (Extend1 � Extend5) of the remote control unit.
To delete the stored memory
Press the [Clr] key in step 5. "Cleared" appears in the display and the memory that is selected in step 4 is erased.
To operate other components by using the stored memory
1 Press the MUSIC, MOVIE, or TV key to select desired input source. � The Menu display appears. 2 Press the [Menu] key . 3 Press the 5/� keys to select the memory you want to operate. 4 Press the [Enter] key.
