WHIRLPOOL RCS10MP
Instrukcja Obsługi

RFS12MPS, RCS10MPS and RCS10MP Control Panel Features

TIME ENTRY

TIME ENTRY pad is used to enter cooking time for either manual entry or programming. Cooking time ranges from 1 second (00:01)

to a total of 60 minutes (60:00) over four stages. If more than 60 minutes of total microwave cooking time is required, open door and inspect food before beginning new cooking cycle.
M I R O D EFR C W ARM M ED H I PO W ER

88:88

8
COOK LE VE L

CLOCK HOLD TIMER READY

X2

X2(some models) pad increases the cooking time when more than one item is cooked.

1
HOLD 0%

Numbered pads begin cooking programs or enter times and power levels for �Manual Time Entry� cooking. This oven can store up to 10 or 100 (some models) cooking programs in memory.
HOLD 0% DEFROST 20% MEDIUM 50% MED-HI 70%

2 3 4 5 6 7 8 9 0

POWER LEVEL (some models)

DEFROST 20% MEDIUM 50% MED-HI 70%

pads are used to set microwave power level. When cooking, the power level can be decreased for foods that require slower more even cooking. If cooking time is set and START pad pressed, oven cooks at 100% power. START pad begins Manual Time Entry cooking or restarts an interrupted cooking

START

TIME ENTRY STOP RESET

cycle. When programming, use to save time and power level, and to save a user option setting.

STOP RESET

STOP/ RESET pad exits programming mode and stop cooking during cooking cycle.

START

88:88

MICRO DEFR WARM MEDHI POWER HOLD TIMER

COOK LEVEL

8

READY CLOCK

Display Some items in display can be seen but are not available.

X2

Stages (some models) This oven can be programmed to run 4 cooking sequences consecutively. Each sequence is called a stage. For example, the first cycle could be programmed to defrost at 20% power, the second to hold at 0% power, the third to heat at 50% power, and the fourth to heat at 100% power. Total time for all cooking stages counts down. User Options User Options allow the user to program the oven to perform in a way convenient to the user. The beeps, maximum cooking time, and number of pre-programmed cooking sequences can be changed.

RCS10MPS and RFS12MPS Only

10