Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 17 (kliknij aby zobaczyć)
Getting Ready
4
Use the Installation Tool supplied with the Wave Expansion Board to turn the holders in the LOCK direction, so the board will be fastened in place.
fig.00-05e
LOCK
Installation tool
5
Use the screws that you removed in step 2 to fasten the cover back in place.
Checking the Installed Wave Expansion Boards
After installation of the Wave Expansion Boards has been completed, check to confirm that the installed boards are being recognized correctly.
fig.00-06p
2
1 2
Turn on the power, as described in �Turning On the Power� (p. 23).
The name of the installed wave expansion board is displayed for as long as EXPANSION [A] or [B] is held down.
The number of tones and Rhythm Sets contained in the expansion board is displayed. The example here depicts what you would see if the SRX-02 �Concert Piano� Wave Expansion Board were installed in the SRX A slot.
fig.00-07g
If �------� appears next to the name of the slot in which the board was installed, it may be that the wave expansion board is not being recognized properly. Use the procedure in �Turning Off the Power� (p. 24) to turn the power off, then reinstall the wave expansion board correctly.
By releasing the button, you go back to the previous screen.
