WHIRLPOOL RF4400XLW0
Instrukcja Obsługi

REPLACING 1.
Be sure surface unit controls are OFF.

4.

While pushing the surface unit terminal into the receptacle, lift a little on the edge of the unit nearest the receptacle. When the terminal is pushed into the receptacle as far as it will go, the surface unit will fit into the reflector bowl.

5.

2.

Line up opening in the reflector the surface unit receptacle.
Terminal

bowl

with

3.

Hold the surface unit as level as possible with the terminal just started into the receptacle.

Reflector bowls reflect heat back to the utensils on the surface units. They also help catch spills. When they are kept clean, they reflect heat better and look new longer. If a reflector bowl gets discolored, some of the utensils used may not be flat enough. Or some may be too large for the surface unit. In either case, some of the heat that is meant to go into or around a utensil goes down and heats the reflector bowl. This extra heat can discolor it.

LIFT-UP

COOKTOP

Be sure surface cool.

units, cooktop

and oven are

2.

1.

Lift the front of the cooktop at the center and swing the support rod up.

Carefully lower the cooktop onto the support rod. Be sure the tip of the rod fits in the notch in the cooktop. Wipe with warm soapy water. Use soapy steel wool pad on stubborn spots. can result.

3.

DO NOT drop the cooktop.

Damage