|
|
|
Kategorie
|
|
Informacje
|
|
Polecamy
|
|
|
Dla tego produktu nie napisano jeszcze recenzji!
MAINTENANCE
8. Place one foot on the front edge of the cutting unit. Raise the front edge of the unit slightly and unhook the height adjustment strut.
9. Remove the bolt and pull out the cutting unit.
Removing the belt
Starting point when Removing the belt: � � No unit attached to the Rider. The front part of the belt hangs loose.
The entire belt is only dismantled as set out below, when the snow plough is fitted on the Rider. � � Remove the guide plate from underneath the drive wheel. Use a 13 mm spanner. Prise the belt off the middle pulley and remove the belt.
8 9
Reverse the above sequence to refit the belt.
26 � English
|
|
 |
> |
|
