CONNECTION / OPERATION The following three sections show examples for: 1. Connecting the inputs 2. Connecting the auxiliary section to a signal processor 3. Connecting the outputs. INPUT CONNECTION EXAMPLE
MODEL RM203 S/N
CONNECTING THE OUTPUTS
MODEL RM203
S/N
203-
OUT
TAPE
IN
MONO
MONO
MONO
MONO
MONO
MONO
MONO
MONO
MONO
MONO
R POWER 12 VAC MADE IN THE U.S.A. RIGHT OUT LEFT OUT AUX RIGHT/MON LEFT SEND AUX RTN AUX RTN RIGHT L LEFT RIGHT LEFT RIGHT LEFT RIGHT LEFT RIGHT LEFT RIGHT LEFT RIGHT LEFT RIGHT LEFT RIGHT LEFT RIGHT LEFT
10
9
8
7
6
5
4
3
2
1
203OUT
TAPE IN R MONO MONO MONO MONO MONO MONO MONO MONO MONO MONO
POWER 12 VAC MADE IN THE U.S.A.
RIGHT OUT
LEFT OUT
AUX SEND
RIGHT/MON LEFT AUX RTN AUX RTN L
RIGHT
LEFT
RIGHT
LEFT
RIGHT
LEFT
RIGHT
LEFT
RIGHT
LEFT
RIGHT
LEFT
RIGHT
LEFT
RIGHT
LEFT
RIGHT
LEFT
RIGHT
LEFT
10
9
8
7
6
5
4
3
2
1
4A 120V - 2A 230 V
OUTPUT 2
OUTPUT 1
SERIAL NUMBER
-
BRIDGE NORMAL OUTPUT 1 MADE IN U.S.A.
RIGHT AND LEFT OUTPUTS MIDI CONTROL RIGHT AND LEFT OUTPUTS FROM EACH SOUND MODULE
MAINS POWER
C O R P O R A T IO N
+
CAUTION
CHANNEL 2 INPUT OUTPUT 2 CHANNEL 1 INPUT
TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT NOT REMOVE LID. NO USER SERVICABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL
+
WARNING For continued prootection against risk of fire, replace only with same type and rating of fuse.
UP TO 9 TOTAL SOUND MODULES
-
To reduce the risk of electric
WARNING:
RISQUE DE CHOC - NE PAS ENLEVER
shock or fire do not expose this device to rain or moisture.
The RM203 is designed to receive line-level signals, thus a microphone or other low input signal will be insufficient to drive the RM203 inputs. Connect the outputs of each instrument or module via a 1/4� cable. AUXILIARY SEND/STEREO RETURN CONNECTION EXAMPLE
MODEL RM203 S/N
203OUT
TAPE IN R MONO MONO MONO MONO MONO MONO MONO MONO MONO MONO
POWER 12 VAC MADE IN THE U.S.A.
RIGHT OUT
LEFT OUT
AUX SEND
RIGHT LEFT AUX RTN AUX RTN
RIGHT L
LEFT
RIGHT
LEFT
RIGHT
LEFT
RIGHT
LEFT
RIGHT
LEFT
RIGHT
LEFT
RIGHT
LEFT
RIGHT
LEFT
RIGHT
LEFT
RIGHT
LEFT
10
9
8
7
6
5
4
3
2
1
MULTI-EFFECTS PROCESSOR
INPUT
RIGHT LEFT OUTPUTS
Connect the RM203 Right and Left Outputs to an amplifier via two balanced TRS 1/4� jacks (two TS unbalanced jacks will work as well).
Connect 1/4� unbalanced cables to the Aux Send to the Input of the signal processor, and connect each signal processor output to its corresponding Aux Return jack. Set the �Mix� control on your signal processor to 100% effect since the dry portion of the signal is mixed in the RM203. NOTE: The RM203 Aux Send jack may also be connected to an amplifier, then to speakers and used as a Monitor Send.
