ELECTROLUX RM6271
Instrukcja Obsługi

6.5

Installation recess
The refrigerator must be installed draught-free in a recess. The measurements of the recess are given in the table below. Step (A) is only required for cabinets with a step. Push the appliance far enough into the recess until the front edge of the refrigerator casing is flush with the front of the recess. Allow a gap of 15-20 mm between the back wall of the recess and the refrigeration unit. The floor of the recess must be level, allowing the appliance to be pushed easily into its correct position. The floor must be substantial enough to bear the weight of the appliance. Ensure that the refrigerator is installed level in the recess.

Recess measurements:
Width of recess = W Width of recess = W

Model
RM RM RM RM RM RM RM RM RM RM RM RM

6270 6271 6290 6291 6360 6361 6400 6401 7270 7290 7360 7400

825 825 825 825 825 825 825 825 825 825 825 825

Hight H
mm mm mm mm mm mm mm mm mm mm mm mm

490 490 529 529 490 490 529 529 490 529 490 529

Width W
mm mm mm mm mm mm mm mm mm mm mm mm

515 mm 515 mm 515 mm 515mm 515 mm 515 mm 515 mm 515 mm 515 515 515 515 mm mm mm mm

Depth T

220 220 220 220 -

Hight HSt
mm mm mm mm

235 235 235 235 -

Depth TSt
mm mm mm mm

220 mm 220 mm -

235 mm 235 mm -

6.6

Securing the refrigerator
In the sidewalls of the refrigerator, there are four plastic sleeves with screws for securing the refrigerator. The sidewalls or rails attached for securing the refrigerator must be designed in such a way that the screws will remain firmly in place even when under increased load (while the vehicle is moving). Always insert screws through the sleeves provided; otherwise, structural parts embedded in the foam, such as cables, etc., may be damaged. Once the refrigerator is in its final position, secure the screws into the wall of the recess. The screws must penetrate through the sheet metal casing of the refrigerator.

21