jedyne do czego mogę mieć zastrzeżenie to jakość zdjęć zawartych w przesłanej instrukcji serwisowej ponieważ są fatalnej jakości, praktycznie nieczytelne. tak poza tym jestem zadowolony to jest to czego szukałem.
Instrukcja jest OK. Schematy czytelne, opisane niektóre procedury.
Tekstowy podgląd strony 18 (kliknij aby zobaczyć)
2-6. Replacing the Printed Wiring Board
2-6-2. Replacing the SW-963 board
1. 2. 3. 4. Pull out the knob. Disconnect the flexible card wire from CN2 on the VA-186 board referring to Section 2-5-1. Remove the CN-1651 board referring to Section 2-6-1. Remove the two screws securing the VA-186 board and remove the board in the direction of the arrow.
Frexible card wire
CN2 B2.6 x 5 VA-186 board
Knob
5. Remove the two screws to remove the board bracket from the SW-963 board. 6. Desolder CN1 on the SW-963 board and remove the SW-963 board from the VA-186 board.
Board bracket
B A SW-963 board
VA-186 board CN1
B2.6 x 5
7. Attach the board bracket that were removed in step 5 to a new SW-963 board with the two screws. 8. Solder CN1 on SW-963 board. The following precautions should be taken before soldering: . Make sure that the SW-963 board is normal to theVA-168 board. . Make sure that the screw holes A and B for the VA-186 board and board bracket are aligned. 9. Install the VA-186 and CN-1651 boards in the reverse order of steps 1 to 4.
