Programming the remote
You can customize the remote to match the components connected to your receiver. You can even program the remote to control nonSony components and also Sony components that the remote is normally unable to control. The procedure below uses as an example a case in which a Aiwa VCR is connected to the VIDEO 2 jacks on the receiver. Before you begin note that:
� You cannot change the settings of TUNER and PHONO. � The remote can control only components that accept infrared wireless control signals. Be sure to turn on the receiver and point the remote towards the receiver when performing the following procedure.
4 Move the easy scroll key to select the
category (i.e., the component that is actually connected to the corresponding jacks; in this case, �VCR�), then press the key to enter the selection.
The maker list appears. Maker? p Sony VTR1 Sony VTR2 Sony VTR3
5 Move the easy scroll key to select the
maker of the component (�Aiwa�, for example), then press the key to enter the selection.
When programming the remote to control Sony component
Select �Sony.� Programming is now completed.
To cancel programming
1 Press RM SET UP.
The set up list appears. p IR SET MENU EDIT AUTO POWER BACK LIGHT
Move the easy scroll key to select �Exit� or �Cancel� during any step, then press the key to enter the selection.
Tips
2 Move the easy scroll key to select �IR
SET�, then press the key to enter the selection.
The IR SET list appears. <IR SET> [VIDEO 1 ] p [VIDEO 2 ] [VIDEO 3 ]
� You can freely assign any component to USER 1 and 2 items in the IR SET list 1 Do steps 1 and 2 in �Programming the Remote�. 2 Move the easy scroll key to select �USER 1� or �USER 2,� then press the key to enter the selection. 3 Continue from step 3 in �Programming the Remote� to select the category and maker of the component. � To operate the tuner on a Sony receiver, make sure that the tuner function�s maker list is set to �Sony STR-02�.
Using the lists
3 Move the easy scroll key to select the
component (�VIDEO 2�, for example), then press the key to enter the selection.
