|
Dla tego produktu nie napisano jeszcze recenzji!
Applying various effects to the sound
â� Vibrato and Wah effects (LFO)
The LFO, short for �low frequency oscillator,� makes changes to the sound in periodic fashion. Changing the pitch with the LFO produces the �vibrato effect,� and by changing the filter cutoff frequency with the LFO, you get what is called the �wah effect.�
fig.q05-03
1 2, 5
4, 7 3, 6
1. 2.
Press the patch modify select button to make the BALANCE/LFO indicator light. Make sure that [FILTER LFO] is off (unlit).
When [FILTER LFO] is off, the two LFO knobs will adjust the vibrato effect. If it is on (lit), press [FILTER LFO] once again so it goes out.
3.
Turn the [LFO DEPTH] knob.
Turning this to the right (clockwise) increases the depth of the undulating sound, while turning it to the left (counterclockwise) makes the undulation shallower and milder.
[FILTER LFO] does not take effect on a rhythm set.
4.
Turn the [LFO RATE] knob.
Turning this to the right (clockwise) increases the speed of the undulating sound, while turning it to the left (counterclockwise) slows the undulation down.
5.
Press [FILTER LFO] so it is lit.
When [FILTER LFO] is on, the two LFO knobs will adjust the wah effect.
6.
Turn the [LFO DEPTH] knob.
Turning this to the right (clockwise) increases the depth of the undulating sound, while turning it to the left (counterclockwise) makes the undulation shallower and milder.
7.
Turn the [LFO RATE] knob.
Turning this to the right (clockwise) increases the speed of the undulating sound, while turning it to the left (counterclockwise) slows the undulation down.
31
Quick Start
|
